1 Inch Universal Handlebars Fat Drag Bar 33 Inch Black

Made in The Netherlands

Westland Customs Special: an oversized Drag bar, 30mm thick! Handmade, custom made for your Harley-Davidson.
Due to the use of 30mm tube in the thick parts, all brake and clutch cylinders of all construction years fit.
Slotted and prepared for e-throttle (Harley-Davidson). The wiring can go inside and all 1 inch controls fit on it.

This handlebar is made of high-quality tubular steel, with a material thickness of at least 2 mm.
These models are TIG welded by hand.
All our handlebars are produced entirely in our own factory in the Netherlands and meet the highest quality standards.

Measurements in millimeters:
A= width, D= Pullback, E= maximum width risers, F= width middle section, G= length grips.

A= 840
D= 100
E= 135
F= 270
G= 195

Please note that it may be required to extend your wiring, cables and/or pipes! Check this to be sure, especially in the case of an ape hanger.
This handlebar fits all motorcycles with 1” (25.4mm) riser grip, levers and grips.

Material:
High-quality cold strip steel (Certified EN 10305-3 CR1 E195 S5)
Tubes of 30x2.5mm, 25.4x2mm
Black powder coating

Pay attention; Westland Customs does not accept any liability with regard to the sharp parts on or on this handlebar! Assembly and use is at all times at your own risk!


For shipments to the UK: all import taxes and costs are included in the price.